Detailed Notes on h4831sc load data

Detailed Notes on h4831sc load data

Blog Article

H1000 is on my wish list of powders as well. Perhaps the IMR Enduron series will probably be well favored and I can move to that for improved availability.

They can be exactly the same detail, but H4831 sc is Minimize shorter so it's going to pack right into a situation simpler then the traditional, and in some cases like our 7mm rem mag it lets us to include much more powder then just the conventional H4831.

Can they be interchanged without concerns other then working with standard load procedures when switching from great deal to great deal?

Minnesota H4831SC is my check out inside the 7mm Rem Mag, but I'm preserving the very little I have remaining for drop 2021. I might start off minimal and operate your way up, based on what load data you look at for this combo the min/max loads are all around the board.

some cartridges are inclined copper foul in excess of others though, regardless of how sleek the end is about the bore and demand cleaning of the copper fouling far more usually.

I have used H4831 and H4831SC in my 260 Rem without having change. The one thing is definitely the small Slice h4831 vs h4831sc will give you a bit more Place. Very good luck!gun)

Hodgdon H4831SC (Short Slash) extruded rifle propellant is often a prime choice for big activity hunters h4831sc load data who use handloader rifles. Launched within the nineteen fifties, this propellant continues to be enhanced with shorter grain measurements which enables better powder stream and even more uniformity.

Im beneath the being familiar with I need to use h4831sc. I've browse that these powders are equivalent Apart from the shorter grain measurement in the sc. Must I still be on the lookout for h4381sc?

Along with the short Lower Model powder will come as much as the base on the decreased shoulder so I still have plenty of space.

locutus explained: I even now have an excellent stockpile of H450, the ball powder equivalent of 4831, which flows through my powder steps easily.

Run your load up with the precise powder (sc or frequent) and large amount you will be working with even though. Exact same melt away amount doesn't suggest it'll behave "exactly" a similar. I've seen around one hundred fps distinction between sc and mil-surp numerous H4831.

This can be an Serious extruded propellant and presents heightened insensitivity to cold and warm temperatures.

Chances are you'll possibly: one) Carry on and have the things h4831sc load data stated underneath automatically removed from your buying cart:

I found that my 7mag one hundred sixty partitions ended up sub MOA with 4831sc with small to min costs. I’m speaking 2700 (possibly 2800) fps, it had been a lower 60s grain demand inside of a Norma case. Not what I was searching for, but accurate Nevertheless.